5.2.2 Time dry
Touch the Time dry button, then enter function, chose the dry temperature and the
drying time, the touch start.
ATTENTION: The maximum measuring / drying time you can set is 99 minutes.
5.2.3 stop mode
When drying, if you need stop the device heat. You can touch the stop button.
ATTENTION: Depending on the temperature, combustion of the sample can easily
occur in this measurement / stop ,mode. This mode should only be used if constant
monitoring can be guaranteed. The advantage of this mode is that the sample can be
dried for a long time to allow moisture to escape which is located very deep in the
sample.
To Next Page
Loading...