5.3 Adjustment / calibration
The moisture analyser consists of a weighing unit and a drying chamber. The moisture
measurement is carried out on the basis of the weight loss. This can be easily
reproduced by a rule of three.
ATTENTION: The moisture analysers of the MA series have a higher weighing
resolution than the one indicated. The moisture balance uses the higher resolution
which is invisible to the user for calculation. This can result in deviations after the
decimal point when trying to reproduce the result.
5.3.1 Span CAL
After touch span cal button, then it will display the capacity of mass weight, then put
on the same weight to do calibration.
To Next Page
Loading...