INDUSTRIAL FIXED GAS DETECTOR, FD-60
FORENSICS DETECTORS
TM
!
!
FORENSICS DETECTORS
TM
www.forensicsdetectors.com
!
** WARNING**
Ø KEEP DETECTOR AWAY FROM ELECTROMAGNETC & MAGNETIC
INTERFERENCES (i.e. PHONES & MAGNETS)
Ø STORE DETECTOR WITHIN SPECIFICATIONS
Ø IF UNWELL, SEEK CLEAN AIR & MEDICAL HELP
Ø ENSURE QUALIFIED PERSONNEL INSTALLS THE UNIT
Ø KEEP AWAY FROM DUST & PARTICULATE AND NEVER EXPOSE TO
EXHAUST GAS or CONCENTRATED VAPORS, HARSH CHEMICALS OR
EXTREMELY HIGH CONCENTRATION LEVELS AS IT MAY POISON THE
SENSOR (SEE APPENDIX FOR RANGES)
Ø FOLLOW INSTRUCTIONS AS THE DETECTOR IS VERY SENSITIVE
Ø Connect the cable according to the Ex request. The end of the cable
need to be treated properly and should be connected to Ex junction box
or equipment. When the detector doesn’t need to work with the
controller, the block is not allowed to take off the cable entrance and
the block have to be kept in the cable entrance closed with the seal
ring.
Ø Don’t open the cover when the power is on.
Ø Pay attention to not break the Ex surface.
To Next Page
Loading...
