To Next PageTo Next Page
Need help?Do you have a question about the FORENSICS DETECTORS FD-60 and is the answer not in the manual?
General| Sensor Type | Electrochemical |
|---|---|
| Display | LCD |
| Operating Temperature | -10°C to 50°C |
| Certifications | CE, RoHS |
| Battery | Rechargeable Lithium-ion |
| Alarm | Audible, Visual, Vibration |
Diagram showing various connections on the detector board like RS485, 4-20mA, sensor, and relays.
Overview of buttons and functions available on the remote control for operating the detector.
Steps for unboxing, connecting the detector, and turning it on/off, including initial stabilization.
Describes how to use the remote control or panel buttons to navigate through different interfaces and menus.
Details the primary menu items such as Back, Setting, Alarm Set, Gas Zero, Gas Check, Alarm Data, and Time Set.
Explains the sub-options within the 'Setting' menu, covering channel, host, max settings, factory reset, system info, and language.
Guide to configuring alarm warning values, modes (LOW/HIGH), and associated relay outputs.
Procedure for zero calibration and recommendation for span calibration by technicians.
Information on accessing and viewing recorded alarm events, including maximum concentration and timing.
How to adjust the detector's time using a backup battery for operational accuracy.
Advice on selecting an appropriate installation site, considering environmental factors and air flow for optimal detection.
Instructions for physically mounting the detector and connecting power/relay wiring, emphasizing professional installation.
