FORENSICS DETECTORS FD-600 - Alarm Settings Management; Configuring Alarm Set Points

!
FORENSICS DETECTORS
TM
www.forensicsdetectors.com
ALARM SETTINGS
AlarmSet: Alarms are triggered (LED flashes only) when alarms points are
met/exceeded. To change the alarm set points select AlarmSet in the Main
Menu (see prior section). A screen to select your gas will appear like the image
below on the left. Select your gas and edit to change the alarm set point /
trigger point as shown in the right image. When alarms are triggered a warning
symbol is shown within the corresponding gas display section within the HOME
DETECTION SCREEN. When triggered, the alarm is highlighted in YELLOW (LOW
alarm) or RED (HIGH alarm) on the HOME Detection Screen. To avoid any
annoying alarm, set the alarm either as LOW or HIGH as possible so the alarms
are not triggered.
ALARM SET
(select gas)
ALARM SET
(Example: O2 alarm value)
Always check the alarm setting to ensure you are protected and alarm
settings are as you anticipate to avoid harmful exposure levels.