4
HOW TO USE BEAR
™
mini
To unlock and register your device for first time use, download the FOREO For You app. Connect to the app via
Bluetooth on your smartphone, and press the universal button on BEAR™ mini to sync your device to the app
and set up your microcurrent preferences.
CAUTION: BEAR
™
mini MUST BE COMPLETELY DRY BEFORE STARTING YOUR MICROCURRENT TREATMENT.
CLEANING YOUR BEAR
™
mini
Always clean BEAR
™
mini thoroughly after use. Wash the metallic spheres and silicone surface with water and
soap, then rinse with warm water. Pat dry with a lint-free, non-abrasive cloth or towel. After use, we recommend
spraying the device with FOREO’s Silicone Cleaning Spray and rinsing with warm water for optimal results.
NOTE: Never use cleaning products containing alcohol, petrol or acetone, as they may irritate the skin and
damage the silicone.
1
2
3
4
Clean and dry your face and neck carefully so
there is no remaining residue of any kind.
Apply SERUM SERUM SERUM to your skin,
distributing it evenly across all the areas you
wish to treat. Massage until fully absorbed.
For Pre-Set Routines:
Select your preferred microcurrent treatment
in the FOREO For You app. Follow the
instructions on the app and continue as
directed. Device will automatically switch off
after routine is complete.
For Manual Mode:
i) Press the universal button to activate
microcurrent. The lights underneath the
universal button indicate the microcurrent
intensity setting. You can change the
microcurrent intensity by quick pressing the
universal button once for each level. To turn
off T-Sonic
™
pulsations, double press the
universal button. Use the app to access a
wider range of microcurrent intensities.
ii) Lightly press both metallic spheres to your
face, and gently glide the device across your
cheekbones and forehead, around your lips,
and over your jawline and neck as desired.
Make sure that both microcurrent spheres are
touching your skin at all times. Always glide
the device slowly, in an upward motion, and
with light pressure for enhanced results.
iii) Once you have finished your treatment,
press and hold the universal button for 3
seconds to turn off the device.
Apply any other skincare products of your
choice, if desired.
To Next Page
Loading...
