-
Please send a text message to the number of the watch with the
content: pw,123456,ts#, in response, the watch will send us the
parameters of the watch. An example:
ver:G36WS_YDE_V1.1_2019.12.19_09.45.40;
ID: 1234567890;
imei:123456789012345;
ip_url:52.28.132.157;
port:8001;
upload:600S;
bat level:96;
language:1;
zone:10.00;
ec:0;
NET:OK(73);
Check the data received in the SMS with the watch number.
- If the number ID/IMEI/REG CODE is different from the badge on the
watch or the bottom of the package, set a new IMEI number.
Please send a text message to the number of the watch with the con-
tent: pw,123456,imei,xxxxxxxxxxxxxxx# where X are the numbers
from the badge - the watch, after receiving the SMS with the code,
sends back in the SMS response with the correct IMEI number, for
example: pw,123456,imei,359614514986574#
Could not call watch. The signal is busy or the subscriber
does not answer
Reason: The watch does not recognize the incoming number or
the app is set to do „not disturb”.
Solution:
-
Check if the number you are calling from is hidden number.
-
Check if there are contact numbers in the application.
Attention
when writing text messages, pay attention to punctuation
marks and spaces. This is very important because if the cha-
racters are not used correctly, the commands will be misin -
terpreted by the watch and will remain unanswered.
To Next Page
Loading...
