FOREVER KW-60 - Device Preferences and Network Settings; Troubleshooting and Safety; Frequently Asked Questions (FAQ)

Time zone: set your time zone than the device shows the correct date and time on.
Language: Choose language for your device from the available.
Settings switch: Enable or disable the watch function.
LBS Location: Enable or disable location using network operators antennas.
Turn off watch remotely: watch will be turned off.
FAQ
The application does not receive commands and shows information that the watch is disconnected from the
network.
Check whether GMS signal is correct– whether the range columns are available / visible on the display. – – – If
they are crossed out, please turn off your watch.
Check if the SIM card is properly installed in the watch, if it supports 2G internet and if there is an internet data
package available.
Turn on the device. If the range columns are still crossed out, go to the next point.
Check if there are data transfer arrows, if not, set APN (Access Point Name – specific packet network, e.g.
internet):
Please send a text message to the number of the watch with the content: pw,123456,apn,internet,,,XXXXX#
* the X character stands for digits assigned to a specific operator
26003 – ORANGE
26001 – PLUS
26006 – PLAY
26002 – T-MOBILE
the remaining code digits are available on manual/forever.eu or www. mcc-mnc.com/
After sending the message, wait several minutes for KidsWatch to download the settings from the network. Data
transfer arrows will appear.
Please send a text message to the number of the watch with the content: pw,123456,ts#, in response, the
watch will send us the parameters of the watch. An example:
ver:G36WS_YDE_V1.1_2019.12.19_09.45.40;
ID: 1234567890;
imei:123456789012345;
ip_url:52.28.132.157;
port:8001;
upload:600S;
bat level:96;
language:1;
zone:10.00;
ec:0;
NET:OK(73);
Check the data received in the SMS with the watch number
If the number ID/IMEI/REG CODE is different from the badge on the watch or the bottom of the package, set a
new IMEI number.
Please send a text message to the number of the watch with the content: pw,123456,imei,xxxxxxxxxxxxxxx# where X
are the numbers from the badge – the watch, after receiving the SMS with the code, sends back in the SMS
response with the correct IMEI number, for example: pw,123456,imei,359614514986574#
Attention