Formech Compac Mini - Electrical Specifications; Transportation; Positioning; Noise Emissions; Machine Storage

Manual - Formech Compac Mini
6
General Arrangement
1- Specification Plate
2- Power Inlet (EC)
3- Power Switch ON/OFF
4- Clamp Frame
5- Material Clamps
6- Heater Box
7- Vacuum / Pressure Valve
8- Table Lever
9- Digital timer
10- Vacuum Pump ON/OFF switch
11- Vacuum Gauge
Mechanical Specifications
Max Material Size: 305mm x 255mm
Max Forming Area: 280mm x 230mm
Max Depth of Draw: 125mm
Overall Width: 440mm
Overall Height: 425mm
Overall Length: 835mm
Weight: 35Kg
Electrical Specifications
Standard Voltage: 208V-240V ac
Frequency: 50-60Hz
Power: 1.1Kw
Compac Mini
7
8
9
10
6
11

6
2
1
4
5
3
Transportation / Positioning
The Compac Mini will be supplied strapped to a Pallet or in a crate. The machine may be unpacked and
placed on a bench, table or Compac Mini trolley. Ensure that the structure, size and load bearing capacity
of the bench or table is sufficient for the machine weight. A minimum of 2 persons are required to lift the
machine. In the case of the Compac Mini trolley, ensure that the 2 machine retaining screws are fitted to the
under side of the trolley / Machine.
Noise emissions
Noise emissions on the Formech Compac Mini are less than 70dB(A).
Machine storage
The Formech Compac Mini must be stored in a dry environment. If the machine is not used for a long period
of time, run the pump periodically (once a month).