To Next PageTo Next Page
Need help?Do you have a question about the Fort VISION and is the answer not in the manual?
This manual provides operational and maintenance information for the VISION model.
Identifies the primary components of the VISION machine as shown in Figure 1/A.
Illustrates safety signs and indicates their locations on the machine.
Describes the operator's workplace, seat sensor, and control levers for movement.
Details the guards and safety devices installed on the machine for protection.
Covers operator training, general safety standards, and definitions of key terms.
Explains the meaning and importance of safety signs displayed on the machine.
Details general safety precautions for operating and maintaining the machine.
Outlines essential checks before starting the machine, including fluid levels.
Provides step-by-step instructions for starting the engine and preparing for operation.
Explains the system for monitoring and managing hydraulic oil temperature.
Advises new operators and details operation of levers for movement and steering.
Explains how to connect various types of interchangeable equipment to the machine.
Describes the process for rotating the operator's seat for forward or reverse operation.
Provides essential warnings and guidelines for operating the machine during work.
Details precautions and limitations when using the machine on inclined or sloping surfaces.
Explains the hydraulic cooling system and emergency shutdown for overheating.
Lists common causes and solutions for the engine failing to start.
Addresses issues with engine power loss and unexpected engine shutdown.
General