Fortinet 548B - Page 119

- 119 -
port-channel linktrap {<logical slot/port> | all}
no port-channel linktrap {<logical slot/port> | all}
<logical slot/port> - The port-channel interface number.
all - all port-channel interfaces.
no - This command disables link trap notifications for the port-channel (LAG). The interface is a
logical slot and port for a configured port-channel. The option all sets every configured port-channel
with the same administrative mode setting.
Default Setting
Enabled
Command Mode
Global Config
7.2.10.6 port-channel load-balance
This command for CLI will configured the mode of load balance on the all Port Channels. The parameter
“
src-mac | dst-mac | dst-src-mac | src-ip | dst-ip| dst-src-ip” represent the mode used to be set for
port-channel load balance.
Syntax
port-channel load-balance all { src-mac| dst-mac | dst-src-mac | src-ip | dst-ip| dst-src-ip }
no port-channel load-balance all
src-mac - Sets the mode on the source MAC address.
dst-mac - Sets the mode on the destination MAC address.
dst-src-mac - Sets the mode on the source and destination MAC addresses.
src-ip - Sets the mode on the source IP address.
dst-ip - Sets the mode on the destination IP address.
dst-src-ip - Sets the mode on the source and destination IP addresses.
no - Restore the mode to be default value.
Default Setting
dst-src-ip
Command Mode
Global Config