Fortinet 548B - Page 120

- 120 -
This command for CLI will configured the mode of load balance on the specific Port Channel. The
parameter “
src-mac | dst-mac | dst-src-mac | src-ip | dst-ip| dst-src-ip” represent the mode used
to be set for port-channel load balance.
Syntax
load-balance { src-mac| dst-mac | dst-src-mac | src-ip | dst-ip| dst-src-ip }
no load-balance
src-mac - Sets the mode on the source MAC address.
dst-mac - Sets the mode on the destination MAC address.
dst-src-mac - Sets the mode on the source and destination MAC addresses.
src-ip - Sets the mode on the source IP address.
dst-ip - Sets the mode on the destination IP address.
dst-src-ip - Sets the mode on the source and destination IP addresses.
no - Restore the mode to be default value.
Default Setting
dst-src-ip
Command Mode
Interface Config
7.2.10.7 port-channel name
This command defines a name for the port-channel (LAG). The interface is a logical slot and port for a
configured port-channel, and name is an alphanumeric string up to 15 characters. This command is used
to modify the name that was associated with the port-channel when it was created.
Syntax
port-channel name {<logical slot/port> | all} <name>
<logical slot/port> - The port-channel interface number.
all - all port-channel interfaces.
<name> - The port-channel name (up to 15 characters) to be configured.
Default Setting
None
Command Mode
Global Config