Fortinet FortiGate FortiGate-100 - Starting the Setup Wizard; Reconnecting to the Web-Based Manager; Connecting the Fortigate Unit to the Network(S)

32 01-28004-0019-20040830 Fortinet Inc.
Starting the setup wizard NAT/Route mode installation
Starting the setup wizard
1 In the web-based manager, select Easy Setup Wizard.
Figure 8: Select the Easy Setup Wizard
2 Follow the instructions on the wizard pages and use the information that you gathered
in Table 5 on page 26 and Table 7 on page 31 to fill in the wizard fields.
3 Select the Next button to step through the wizard pages.
4 Confirm the configuration settings, and then select Finish and Close.
Reconnecting to the web-based manager
If you changed the IP address of the internal interface while you were using the setup
wizard, you must reconnect to the web-based manager using the new IP address.
Browse to https:// followed by the new IP address of the internal interface. The default
address of the internal interface is https://192.168.1.99.
You are now finished the initial configuration of the FortiGate unit, and can proceed to
“Next steps” on page 34.
Connecting the FortiGate unit to the network(s)
When you have completed the initial configuration, you can connect the FortiGate unit
between your internal network and the Internet.
There are three 10/100Base-TX connectors on the FortiGate-100:
• Internal for connecting to your internal network,
• External for connecting to the Internet,
• DMZ for connecting to a DMZ network.
Antivirus
High Create a protection profile that enables virus
scanning, file blocking, and blocking of oversize
email for HTTP, FTP, IMAP, POP3, and SMTP. Add
this protection profile to a default firewall policy.
Medium Create a protection profile that enables virus
scanning, for HTTP, FTP, IMAP, POP3, and SMTP
(recommended). Add this protection profile to a
default firewall policy.
None Do not configure antivirus protection.
Select one of these security levels to protect your network from viruses.
Table 7: Setup wizard settings
Note: If you use the setup wizard to configure internal server settings, the FortiGate unit adds
port forwarding virtual IPs and firewall policies for each server. For example, for each server
located on the Internal network the FortiGate unit adds an External->Internal firewall policy.