Fortinet FortiGate FortiGate-3016B - Page 17

Installing the FortiGate unit Powering on the FortiGate unit
FortiGate-3016B, FortiGate-3600A and FortiGate-3810A FortiOS 3.0 MR5 Install Guide
01-30005-0343-20071113 17
The FortiGate unit starts and the Power and Status LEDs light up. The Status
LEDs flash while the FortiGate unit starts up, and remain lit when the system is
running.
Table 1: LED indicators for the FortiGate-3600A and FortiGate-3810A
Table 2: LED indicators for the FortiGate-3016A
Note: If only one power supply is connected, an audible alarm sounds to indicate a failed
power supply. Press the red alarm cancel button on the rear panel next to the power supply
to stop the alarm.
LED State Description
Power Green The FortiGate unit is powered on.
Off The FortiGate unit is powered off.
Staus Green The FortiGate unit is on and running normally.
Flashing The FortiGate unit is starting up
Hi-Temp
FortiGate-3600A
Green The internal temperature has reached abnormally high
temperatures.
Off Normal internal temperature range.
Interface LEDs Green The correct cable is in use and the connected
equipment has power.
Ports 1 to 8 connect at 10/100/1000 Mb.
Ports 9 and 10 connect at up to 1000 Mb.
Flashing
Green
Network activity at this interface.
Off No link established.
LED State Description
Power Green The FortiGate unit is powered on.
Off The FortiGate unit is powered off.
Staus Green The FortiGate unit is on and running normally.
Flashing The FortiGate unit is powered off.
Port 1 and 2
(Right)
Green The correct cable is in use and the connected
equipment has power.
Flashing
Green
Network activity at this interface.
Port 1 and 2
(Left)
Green Connection at 1000 Mb.
Amber Connection at 100 Mb
Off Connection at 10 Mb.
Port 3 to 18 Green The correct cable is in use and the connected
equipment has power.
Flashing
Green
Network activity at this interface.