116 Fortinet Inc.
Adding firewall policies Firewall configuration
Figure 5: Adding a NAT/Route policy
Firewall policy options
This section describes the options that you can add to firewall policies.
Source
Select an address or address group that matches the source address of the packet.
Before you can add this address to a policy, you must add it to the source interface. To
add an address, see “Addresses” on page 122.
Destination
Select an address or address group that matches the destination address of the
packet. Before you can add this address to a policy, you must add it to the destination
interface. To add an address, see “Addresses” on page 122.
To Next Page
Loading...
