FortiGuard Analysis and Management Service Version 1.2.0 Administration Guide
18 13-12000-406-20081031
Configuring a device to use the service Setup
To configure remote logging to the service
1 In the FortiGate web-based manager, go to Log&Report > Log Config > Log
Setting.
Figure 5: FortiGuard logging options in Log Setting
2 Select the Expand Arrow beside Remote Logging to reveal the available options.
3 Select FortiGuard Analysis Service.
If this check box is grayed out, authorize the device from the portal web site and
configure the Service Account ID before performing this step. For more
information, see “To configure the Service Account ID and validate connectivity”
on page 16.
4 From “When log disk is full”, select what the service should do when the device
reaches its quota: either Overwrite oldest logs or Do not log.
5 From “Minimum log level”, select one of the following log severity levels:
Messages with an equal or lesser severity will be sent to the service.
6 Select Apply.
To configure remote management by the service
1 In the FortiGate web-based manager, go to System > Admin > Central
Management.
0 - Emergency The system has become unstable.
1 - Alert Immediate action is required.
2 - Critical Functionality is affected.
3 - Error An error condition exists and functionality could be affected.
4 - Warning Functionality could be affected.
5 - Notification Information about normal events.
6 - Information General information about system operations.
Note: Daylight Savings Time (DST) may affect your location. It is recommended to verify if
your location observes this change, since it affects the accuracy and schedule of logs. For
more information, see the Fortinet Knowledge Center article, New Daylight Saving Time
support.
To Next Page
Loading...