Fortinet FortiGuard Analysis and Management Service 1.2.0 - Expanding or Renewing Service

Setup Expanding or renewing service
FortiGuard Analysis and Management Service Version 1.2.0 Administration Guide
13-12000-406-20081031 19
Figure 6: Central Management options
2 Select the check box beside Enable Central Management.
3 From Type, select FortiGuard Management Service.
4 Select Apply.
5 Select any of the following options that you want enabled:
6 Select Apply.
Expanding or renewing service
You can expand or renew the service after accessing the portal web site for the
first time. The Fortinet Technical Support web site allows you to expand or renew
the service after a trial contract expires, or after you have purchased a full
contract.
Allow automatic
backup of
configuration on
logout/timeout
Automatically upload a new configuration revision to the service
when an administrator logs out or the session times out.
Most configuration changes cause an automatic backup.
Exceptions include VPN certificates, topology, FortiGuard license
status, host name, high availability (HA) override and priority, and
network interface media access control (MAC) address.
Allow configuration
updates initiated by
the management
server
Allow the device to receive configuration changes scheduled
from the portal web site.
Allow script updates
initiated by the
management server
Allow the device to receive script changes scheduled from the
portal web site.
Allow firmware
upgrades initiated by
the management
server
Allow the device to be upgraded by the management server.
Note: The options for the service in Central Management appear only after you have
configured the Service Account ID.