Factory Reset
Factory Reset
Follow the steps below to perform factory reset on FortiSIEM FSM-2000G.
l
Step 1: Uninstall FortiSIEM Application
l
Step 2: Reinstall FortiSIEM Application
Step 1: Uninstall FortiSIEM Application
1.
Connect FortiSIEM device using VGA or Console port.
2. Login as root user with the new password you set in Step 3: Verify System Information.
3.
To check the available FortiSIEM commands, run sudo get.
4.
To uninstall FortiSIEM, run sudo execute fsm-clean.
This script will uninstall FortiSIEM application.
5.
Reboot the system.
Step 2: Reinstall FortiSIEM Application
1.
Login as root with password ProspectHills. You will immediately be asked to change your password.
2.
To configure RAID, run execute format disk.
3.
To check Hardware status and RAID information, run diagnose hardware info.
4.
To install FortiSIEM, run the factoryreset –-force command. The command fails after partial steps. Run
the same command again to complete factoryreset.
This script takes a few minutes to complete FortiSIEM installation.
5.
Reboot and run /user/local/bin/configFSM.sh to install FortiSIEM.
Follow the steps under Appliance Setup to configure FSM-2000G.
FortiSIEM 6.6.2 2000G Hardware Configuration Guide 24
Fortinet Inc.
To Next Page
Loading...
