Fortinet FortiSwitch-548B v. 5.2.0.2 - Page 167

- 167 -
7.3.4 SSH Client Session Commands
7.3.4.1 ssh
This command establishes a new outbound ssh connection to a remote host.
Syntax
ssh <ip-address|hostname> <username> { [port <1-65535>] [protocol <protocollevel>] | [protocol
<protocollevel>] [port <1-65535>]}
<ip-address|hostname> - A hostname or a valid IP address.
<username> - user account.
[port] - A valid decimal integer in the range of 1 to 65535, where the default value is 22.
[protocol] - SSH Protocol Level (Version) 1 or 2.
Default Setting
None
Command Mode
Privileged Exec
7.3.4.2 sshc sessions
This command regulates new outbound ssh connections. If enabled, new outbound ssh sessions can be
established until it reaches the maximum number of simultaneous outbound ssh sessions allowed. If
disabled, no new outbound ssh session can be established. An established session remains active until
the session is ended or an abnormal network error ends it.
Syntax
sshc sessions
no sshc sessions
no - This command disables new outbound ssh connections. If disabled, no new outbound ssh
connection can be established.
Default Setting
Enabled
Command Mode
Global Config