Fortinet FortiSwitch-548B v. 5.2.0.2 - Page 172

- 172 -
7.3.5.5 snmp-server contact
This command sets the organization responsible for the network. The range for contact is from 1 to 31
alphanumeric characters.
Syntax
snmp-server contact <con>
<con> - Range is from 1 to 31 alphanumeric characters.
Default Setting
None
Command Mode
Global Config
7.3.5.6 snmp-server community
This command adds (and names) a new SNMP community. A community name is a name associated
with the switch and with a set of SNMP managers that manage it with a specified privilege level. The
length of the name can be up to 16 case-sensitive characters.
i
Community names in the SNMP community table must be unique. If you make multiple
entries using the same community name, the first entry is kept and processed and all
duplicate entries are ignored.
Syntax
snmp-server community <name>
no snmp-server community <name>
<name> - community name (up to 16 case-sensitive characters).
no - This command removes this community name from the table. The name is the community name
to be deleted.
Default Setting
Two default community names: public and private. You can replace these default community names
with unique identifiers for each community. The default values for the remaining four community
names are blank.
Command Mode
Global Config