Fortinet FortiSwitch-548B v. 5.2.0.2 - Page 259

- 259 -
7.8.4 Radius Configuration Commands
7.8.4.1 radius accounting mode
This command is used to enable the RADIUS accounting function.
Syntax
radius accounting mode
no radius accounting mode
no - This command is used to set the RADIUS accounting function to the default value - that is, the
RADIUS accounting function is disabled.
Default Setting
Disabled
Command Mode
Global Config
7.8.4.2 authorization network radius
Use this command to enable the switch to accept VLAN assignment by the radius server.
Syntax
authorization network radius
no authorization network radius
no - Use this command to disable the switch to accept VLAN assignment by the radius server.
Default Setting
Disabled
Command Mode
Global Config