Fortinet FortiSwitch-548B v. 5.2.0.2 - Page 272

- 272 -
Syntax
cdp
no cdp
no - This command is used to disable CDP Admin Mode.
Default Setting
Enabled
Command Mode
Global Config
7.9.2.2 cdp run
This command is used to enable CDP on a specified interface.
Syntax
cdp run
no cdp run
no - This command is used to disable CDP on a specified interface.
Default Setting
Enabled
Command Mode
Interface Config
This command is used to enable CDP for all interfaces.
Syntax
cdp run all
no cdp run all
all - All interfaces.
no - This command is used to disable CDP for all interfaces.
Default Setting
Enabled