- 431 -
8.2.2.6 ip route precedence
This command sets the default precedence for static routes. Lower route preference values are
preferred when determining the best route. The "ip route" and "ip default-next-hop" commands allow you
to optionally set the precedence of an individual static route. The default precedence is used when no
precedence is specified in these commands. Changing the default precedence does not update the
precedence of existing static routes, even if they were assigned the original default precedence. The
new default precedence will only be applied to static routes created after invoking the "ip route
precedence" command.
<1-255> - Default precedence value of static routes. The range is 1 to 255.
Default Setting
The default precedence value is 1.
Command Mode
Global Config
8.2.2.7 ip mtu
This command sets the IP Maximum Transmission Unit (MTU) on a routing interface. The IP MTU is the
size of the largest IP packet that can be transmitted on the interface without fragmentation.
<68-9198> - The IP MTU on a routing interface. The range is 68 to 1500.
no - Reset the ip mtu to the default value.
Default Setting
The default value is 1500.
Command Mode
Interface Config
To Next Page
Loading...
