Fortinet FortiSwitch-548B v. 5.2.0.2 - 8.3 Open Shortest Path First (OSPF) Commands

- 432 -
8.2.2.8 encapsulation
This command configures the link layer encapsulation type for the packet.
Syntax
encapsulation {ethernet | snap}
ethernet - The link layer encapsulation type is ethernet.
snap - The link layer encapsulation type is SNAP.
Default Setting
The default value is ethernet.
Command Mode
Interface Config
Restrictions
Routed frames are always Ethernet encapsulated when a frame is routed to a VLAN.
8.3 Open Shortest Path First (OSPF) Commands
8.3.1 Show Commands
8.3.1.1 show ip ospf
This command displays information relevant to the OSPF router.
Syntax
show ip ospf
Default Setting
None
Command Mode
Privileged Exec
Display Messages
!
Some of the information below displays only if you enable OSPF and configure certain
features.