Fortinet FortiSwitch-548B v. 5.2.0.2 - Page 475

- 475 -
no - This command is used to cancel the advertisement of default routes.
Default Setting
Not configured
Command Mode
Router RIP Config
8.5.2.5 default-metric
This command is used to set a default for the metric of distributed routes.
Syntax
default-metric <1-15>
no default-metric
<1 - 15> - a value for default-metric.
no - This command is used to reset the default metric of distributed routes to its default value.
Default Setting
Not configured
Command Mode
Router RIP Config
8.5.2.6 distance rip
This command sets the route preference value of RIP in the router. Lower route preference values are
preferred when determining the best route.
Syntax
distance rip <1-255>
no distance rip
<1 - 255> - the value for distance.
no - This command sets the default route preference value of RIP in the router.
Default Setting
15