- 639 -
11.2.5.3 Configuring Command Logger Page
Selection Criteria
Admin Mode - Enable/Disable the operation of the CLI Command logging by selecting the
corresponding pulldown field and clicking Submit.
Command Buttons
Submit - Update the switch with the values you entered.
11.2.5.4 Configuring Console Log Page
This allows logging to any serial device attached to the host.
Selection Criteria
Admin Status -A log that is "Disabled" shall not log messages. A log that is "Enabled" shall log
messages. Enable or Disable logging by selecting the corresponding line on the pulldown entry field.
Severity Filter - A log records messages equal to or above a configured severity threshold. Select
the severity option by selecting the corresponding line on the pulldown entry field. These severity
levels have been enumerated below:
Emergency (0): system is unusable
Alert (1): action must be taken immediately
To Next Page
Loading...
