Fortinet FortiSwitch-548B v. 5.2.0.2 - Page 651

- 651 -
11.2.6.6 Configuring Double VLAN Tunneling Function Page
Selection Criteria
Slot/Port - Select the physical interface for which you want to display or configure data.
Configurable Data
Interface Mode - This specifies the administrative mode via which Double VLAN Tagging can be
enabled or disabled. The default value for this is Disabled.
Interface EtherType - The two-byte hex EtherType to be used as the first 16 bits of the DVlan tag.
 802.1Q Tag - Commonly used tag representing 0x8100
 vMAN Tag - Commonly used tag representing 0x88A8
 Custom Tag - Configure the EtherType in any range from (0 to 65535)
Command Buttons
Submit - Update the switch with the values on this screen. If you want the switch to retain the new
values across a power cycle, you must perform a save.