EasyManuals Logo

Fortress Technologies FDH2814 User Manual

Fortress Technologies FDH2814
11 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #5 background imageLoading...
Page #5 background image
3
OPERATION INSTRUCTION
*Connect the power cord to the correct power supply (220-240V, ~50Hz).
1. ON/OFF button
Press the ON/OFF button to turn on the dehumidifier. “50%” will be displayed on the LCD display
for 2 seconds, and the room humidity will be displayed afterwards. ,
will be flashed in cycle and will be on at the same time.
The preset mode is dehumidifying by 50%, medium wind speed and air deflector function on. Press
the ON/OFF button again to turn off the dehumidifier.
2. Humidity setting button %
Press the humidity setting button to set the desired dehumidifying percentage. Press the Up/Down
button to set the humidity (a range of CO, 30% to 80%.). For each press, the set humidity will be
increased / decreased by 5%. CO” and will be displayed on the LCD display, and the
dehumidifier will be operated continuously. The room humidity will be displayed after 5 seconds.
Humidity setting will be completed.
Effect of humidity setting to operation state:
If the appliance is operated in continuous dehumidifying mode, its operation will not be
influenced by the change of the ambient humidity.
If the appliance is operated in non-continuous dehumidifying mode, humidity control system
will be started in 5 minutes after start-up. If the setting-up humidity is 3% higher than the actual
humidity, the compressor will be stopped with the fan keep working. If the setting-up humidity
is 3% lower than actual humidity, the compressor will be restarted.
3. Timer button
Auto off timer (1-24 hours) can be set. Press the timer button, the timer indicator and
will be on, and the setting-up time will be flashed on the LCD display. The original set value is 00.
Press the Up/Down button in 5 seconds to set the auto off timer. For each press, the set auto off time
will be increased / decreased by 1 hour. The room humidity will be displayed after 5 seconds. Auto
off timer setting will be completed.
Note: Press the timer button for 3 seconds continuously to cancel the timer.
4. Mode button
Press the mode button to select different operating modes, press once to change the modes among
laundry drying ( will be flashed on LCD display) purifying ( will be flashed on
LCD display) shoes drying function ( will be flashed on LCD display).
Laundry drying mode: the appliance runs with high fan speed and dehumidifying for 6 hours then
switch off automatically. The fan speed can be selected.
Purifying mode: the appliance runs with high fan speed without dehumidifying. The fan speed
cannot be selected.
Shoes drying mode: the appliance runs with medium fan speed and dehumidifying continuously.
The fan speed can be selected.

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Fortress Technologies FDH2814 and is the answer not in the manual?

Fortress Technologies FDH2814 Specifications

General IconGeneral
BrandFortress Technologies
ModelFDH2814
CategoryDehumidifier
LanguageEnglish

Related product manuals