5
Yale Z-Wave Plus ™ Product Info
Manufacturer ID: ASSA ABLOY (0x0129)
Z-Wave
™
Device Type: Door Lock Keypad
Z-Wave
™
Role Type: Listening Sleeping Slave (LSS)
Network Operations
Enroll/Add device to network (SmartStart)
SmartStart enabled products can be added into a Z-Wave
™
network by scanning the
Z-Wave™ QR Code present on the product with a controller providing SmartStart
inclusion. No further action is required and the SmartStart product will be added
automatically within 10 minutes of being switched on in the network vicinity.
• Open the Z-Wave
™
system’s smart home app via smartphone or tablet and
follow the in-app prompts to add a new device.
• SmartStart works when the Z-Wave
™
system has the DSK saved and one of
the following are true:
o The lock has the minimum Radio Module firmware version AND is in a
factory-reset state:
▪ AYR-MOD-ZW3-USA: v2.40
• NOTE: If AYR-MOD-ZW3-USA @ FW v2.39 is inserted in
lock
o Known Issue
The Configuration Set Command wrapped in
Supervision Command Class will report a failure
status in the Supervision Report even though the
parameter’s value was updated.
Steps to Avoid
Option 1: The Configuration Report Command must
be used to validate the success of the Configuration
Set Command and the parameter’s value change.
Option 2: Use the Configuration Set Command not
wrapped in Supervision Command Class.
o The lock has the minimum Lock firmware version AND is in a factory-
reset state:
▪ YRD410/420/430/450: v1.3.14
▪ YRD614/624/634/654: v1.3.14
o An internal key has already been established.
To Next Page
Loading...