Impact point does not coincide with aiming
point
Possible cause
Display calibration required.
Solution
Calibrate the display in accordance with the instruction in the section
Display Calibration.
Possible cause
The device is not securely mounted on the riflescope, or the riflescope
on the rifle.
Solution
Check that the device is firmly fixed on the riflescope and that the
mounting of the riflescope to the rifle is secure.
Ensure that you are using the very type of ammunition that was
previously fired from your rifle.
If you zero a riflescope in summer and then use it in winter (or vice
versa), some change in the zero point of the zeroing cannot be
discounted.
The attachment slides off the riflescope
during firing
Possible cause
Adapter insufficiently clamped.
Unsuitable insert selected.
To Next Page
Loading...