5
⚫ Do not look directly at the light source from close range.
⚫ Take precautions to prevent injury due to falls when working at height.
⚫ For permanent installation, ensure that the fixture is securely fastened to a
load-bearing surface with suitable corrosion-resistant hardware.
⚫ For temporary installation with clamps, ensure that the quarter-turn
fasteners are turned fully and secured with a suitable safety cable. The
cable must be approved for a safe working load (SWL) of 10 times the
weight of the fixture, and it must have a minimum gauge of 3 mm.
3. Preparing for installation
Unpack the fixture and inspect it to ensure that it has not been damaged during
transport.
The fixture is shipped with two quarter-turn brackets, that can be used to
mount the fixture at elevation.
The fixture is IP65-rated, and is designed for use in wet locations. This means
that it is protected from:
⚫ Dust, to the degree that dust cannot enter the fixture in sufficient
quantities as to interfere with its operation.
⚫ Lower pressure jets of water from any direction.
When selecting a location for the fixture, ensure that:
⚫ It is situated away from public thoroughfares and protected from contact
with people.
⚫ It is not immersed in water or exposed to high-pressure water jets.
⚫ It has adequate ventilation.
To Next Page
Loading...