FOS Technologies CYCLONE PRO D2 - Manual Color Setting; Stand-Alone Operation; Connecting to DMX Control

8
Setting a static color manually
The fixture can be configured to display a predefined and static color using the
“Manual Color” (see “Control menu” on page 13).
It may suit your needs when you without a DMX controller to do the color
mixing.
Using stand-alone operation
Stand-alone operation is where the fixture is not connected to a control device,
but is preprogrammed with 2 modes (Auto Color, Auto Fade), that play
continuously in a loop, the run speed of “Auto Color”, “Auto Fade” are
adjustable.
To define a stand-alone program, use the “Auto Program” menus (see “Control
menu” on page 13).
7. Connecting to a DMX control device
The fixture is controllable using a DMX control device and it can be connected
using a DMX cable.
If using a cabled DMX system, connect the DMX in cable (with male 3-pin XLR
plug) and out cable (with female 3-pin XLR plug) to the DMX data link.
Terminate the DMX out cable of the last fixture in the data link. For outdoor
installations, use only IP-rated XLR connectors suitable for outdoor use.
The DMX512 is widely used in intelligent lighting control, with a DMX 512
controller. connect several lights together, DMX in and DMX out, 3 pin XLR
connectors: Pin 1: GND, Pin 2: Negative signal (-), Pin 3: Positive signal (+)