Quick Installation Guide
V1.0
EQC00006
2 Hardware Introduction1 Instructions
Note:
If your device fails to connect to the Wi-Fi using the
Setup Wizard, you can also use WPS mode or the SoftAP
connection. Please refer to the User Manual on the
Foscam website at http://www.foscam.com.
Package Contents
Model: C1 Lite
Quick Installation Guide
Warranty Card
IP Camera
AC Adapter
USB Power Cable
Quick Installation Guide
Model: C1 Lite
You can add the Foscam camera using a smartphone.
Security Warning
Foscam cameras and NVRs require good security
practices to safeguard your privacy. You should
regularly change your camera or NVR password which
is 8-10 numbers, letters, symbols combination.
You should update your camera or NVR regularly. Make
sure your camera or NVR has the latest rmware
installed for your specic model and better experience.
3 Download Foscam APP 4-1 Wireless Connection 4-2 Wireless Connection
Micro SD Card Slot
Lens
Network light
Power light
Microphone
WPS/Reset
Power
SoftAP
If you have a QR Code APP on your phone, scan the
code below.
You can simply go to the App Store or Google Play Store
and search for the term "Foscam". Find the app that
appears with the same icon as shown above, and
download it to your device.
Foscam
Make sure your wireless router is enabled DHCP feature,
and connected to internet.
Make sure your smartphone is connected to your
wireless router and located near the camera.
Before you continue, please note:
1. Connect the power adapter to the camera. Then the
camera will play a sound ”Ready for WiFi conguration” ,
It indicates that the camera is in EZLink mode.
2. Run the Foscam APP , and then register for a
Foscam account. After logging in, please follow bellow
steps to add your camera.
EZLink
WLAN:
WLAN Password:
Connect your phone to Wi-Fi and input Wi-Fi
password for camera to connect.
NPU5YHSZSADVC59D111ABZZZ
doc
QR Code UID
CONNECT
EZLink
Please put the QR code within the frame. Put the
barcode outside the frame to avoid interference.
Album
Scan
Tap here
Tap here
Tap here
Scan the
QR code
The camera will
play
a sound
“Wireless
Connection
Succeed” .
Enter your Wi-Fi
passw
ord.
Tap ‘+’ to add new camera
Add New Camera
My Cameras
Tap to scan QR Code
Please scan the QR code on
your camera to add.
Setup Wizard
轻触扫描二维码
√
Connection succeeded！
Tap the camera in the list to
watch live video.
Setup Wizard
To install the Foscam APP on your smartphone, you can
choose either of the following methods:
Router
WiFi
To Next Page
Need help?
General
