Foscam FI9818W - Page 80

www.foscam.com
Shenzhen Foscam Intelligent Technology Co., Limited
Tel: 86 755 2674 5668 Fax: 86 755 2674 5168
77
Figure 4.80
There are other buttons between the Preset points and Cruise track, you can use these buttons to adjust
the order of preset points or add/delete one preset points in one cruise track.
Figure 4.81
Add: Select one preset points and add it to the selected cruise track.
Delete: Select one preset points you have added to one cruise track, click delete.
Move up/ down: Select one cruise track, adjust the order of preset points in one cruise track.
Attention:
Considering the life time and thermal issue of the motor, it’s not recommend to do long-time cruise.
4.8.3 Start-Up Options
Here section will allow you to set the stop position after the camera reboots.
It supports three modes: No self test, Goto home position and Goto preset point.
No self test: When rebooting, the camera will not pan / tilt.
Goto home position: When rebooting, the camera will pa Providing Central Management Software to