Foster 2998100 - Appliance Description (Pag.20); Characteristics (Pag.19); Data Plate; Lubrication System

Instruction manual CHARACTERISTICS Coffee Machine
Page 19 of 28
Data plate
 Supply voltage
230VAC – 50Hz
 Nominal absorption
850W
 Frame material
Metal
 Dimensions (LxHxD)
mm, packaging
excluded
595 x 452 x 312
 Weight (kg), with
empty tank
20 kg
 Lenght of the power
cord
1,5 mt
 User interface
Touch buttons on glass,
backlit
 Water tank
Removed from the front
 Water capacity
2,5 lt
 Temperature control
Electronic with NTC
probe
 Pump pressure
20 bar
 Water heating
system
With heat exchanger
 Steam production
system
With independt heat
exchanger
 Safety device for
dispensing
Valve operated in the
presence of the pod
 Safety device
temperature
Thermostat with manual
reset
Appliance complies with standards EC 2006/95 and EC
2004/108.
Pods in filter paper standard E.S.E.
The dispensing unit of
this machine is suitable
to dispense: espresso,
tea, barley, etc., in
standard pods ESE (Easy
Serving Espresso).
The group allows you to
use pods of 44mm with 7
gr. of coffee powder
standard E.S.E. (single
dose quantity).
Use different sizes of
pods, does not guarantee
a good supply.
System about emptying of exchangers
The appliance has been designed with a hydraulic
system that allows emptying the exchangers coffee
about the water vapor remaining at the end of each
disbursement.
The advantage of this system, it is to not have the
hydraulic circuit in pressure and in temperature when
the machine is in stand-by, that to prevent the
calcification of the water in the ducts.
Lubrication system of the heat exchanger
coffee
The hydraulic connections of the appliance, were
made so as to discharge the internal pressure of the
exchanger coffee, recovering the fatty residues of
disbursements, this allows a continuous lubrication of
internal ducts, by protecting them against limescale.
Automatic switch-off system ESS (Energy
Saving System)
An electronic control timer, turns off the heat
exchanger steam if not occur disbursements of these
for 5 minutes. To dispense steam, we will have to
select the steam button and wait until the
temperature reaches the optimal level of provision.
Also, if you are not using the unit for 15 minutes, the
unit automatically goes into stand-by mode (functions
and lights off, remains active illumination at low
intensity of the control panel).
EN