Instruction manual Problems-Causes-Remedies Coffee Machine
Page 26 of 28
The appliance does not turn on
The appliance is not connected to
the mains.
Check the connection to the mains.
It is not put the switch to "ON" (1).
It has blown fuse in the plug of the
power cord.
Dispensing absent after the key
selection.
The appliance has entered stand-by
mode.
Press the On/Off button on the
control panel.
It is indicated the "empty tank"
No dispense hot water or steam
from the "spear".
The heating element of the brew
group has not yet reached its
operating temperature
Wait until the service light interested
(hot water or steam) to stop blinking.
First make a cleaning with hot water
and detergent only the steam tube.
Perform a descaling cycle.
Dispensing scarce or absent.
Erroneous position of the suction
tube inside the tank water.
Check the correct position of the
pipe into the bottom of the tank.
Formation of calcareous concretion
in the circuit.
Perform a descaling cycle with
suitable products.
The coffee runs out of the pods
drawer.
Correctly position the pod.
Remove the filter from the drawer
and wash it.
Water comes out from the drip tray.
Remove drip tray and empty it.
To Next Page
Loading...