Foster EP700LL - Page 15

15
G3 Cabinets - User Manual
Before calling your supplier please make sure that:
CheckProblem Solution
If the reason for the malfunction cannot be identied, disconnect the electrical supply from the appliance and
contact your authorised dealer or Foster Service. When requesting a service call, please quote the model and
serial number which can be found on the inside of the appliance on the right hand wall and begins with ‘E’.
The appliance is not functioning Is the appliance plugged in and
the socket switched on?
If the appliance is plugged in
check that the socket is ‘live’ by
plugging another appliance in to
see if that works.
Has the fuse blown? Check the fuse and if necessary
change it for a new one
The appliance is not cooling or
it is not reaching the required
temperature
Is the appliance switched on? Check that the temperature is
displayed. If the display shows ‘oFF’
switch on the appliance as it is in
standby
Is the condenser blocked or dirty? Inspect and clean the condenser
if necessary as described in this
manual
Is the appliance positioned close
to a heat source?
Is the heat source aecting the
performance of the appliance. If
possible move the appliance away
from the heat source.
Is the appliance loaded correctly? Check the loading of the product
contained in the appliance is in
accordance with the guidelines in
this manual
There is something other than
the temperature displayed on the
controller
Is the display showing one of the
alarms/warnings above?
The display may show indications
shown in the ‘Alarms and
Warnings’ section of these
instructions. For anything else
contact your authorised dealer or
Foster Service.