8
www.fosterrefrigerator.com
Start-Up and Test Sequence
After unpacking, clean (cleaning directions supplied within this manual) and allow the appliance to stand
for 60 minutes before turning on.
Ensure the appliance is situated on a rm, level
surface, away from both hot and cold air sources, as
this will aect its performance.
Place the appliance in a location so as not to exceed
the maximum rated ambient temperature.
The appliance produces warm air when operating
normally and requires adequate ventilation. The
dimensions indicated are a minimum.
The air intake slot at the front of the appliance MUST
be unobstructed across the full width of the
appliance.
As the operating temperature has been pre-set no adjustments are required. Allow the appliance
to reach its normal operating temperature before loading with product.
Connect the appliance to a suitable power supply.
Do not connect or disconnect the appliance with
wet hands. The appliance will turn on automatically
displaying the actual internal temperature of the
appliance and ‘PF’. To cancel the alarm press
button 1. If this does not happen and the display
shows ‘ - ‘ press and hold button 1 for 3 seconds to
turn on the appliance.
500mm
50mm
50mm
To Next Page
Loading...
