Foster FS90 - Power Supply Connection; Initial Start Up Procedure

Inial start up
Prior to using the machince.
1. Ensure that the machine has not been damaged during transport
2. Remove any items from the ice bin
3. Clean inside the container with a damp sponge with warm water
and a lile sodium bicarbonate; rinse with clean water and dry carefully
English
Before starng the machine ensure the following is carried out before starng
the unit.
Note: A minimum fall of 3% is needed to ensure adequete water ow
from the machine. Care should be taken to ensure the drain
pipes are not restricted in any way.
8
Connecng the power supply.
If the power supply cable is damaged, it must be replaced by qualied personnel to prevent any hazards to
persons.
Connect the machine to a suitable power supply.
When connecng the machine, ensure hands are dry and the socket is switched o
Connect the machine to the power supply only aer having veried that the mains voltage
corresponds to that on the serial number plate on the rear panel of the appliance.
(On page 10 of the manual)
The maximum voltage variaon tolerance allowed is ± 10% of the rated value.
It is recommended that the machine is installed with its own isolator switch as all pole contact separaon.
All cables and isolators must be sized according to the rang indicated on the serial number plate.
(On page 10 of the manual)
The socket must be easily accessible.
4
6
7