Fostex E-2 - Recording and Overdubbing; Punch In;Out Procedures

15
LED will be lit in green and tape will be transported in the record
ready state,
5.3 Recording
1) Set each MONITOR selector (17) to INPUT and check for proper input
levels applied to the E-2/E-22 with the VU meter.
2) Depress the RECORD TRACK selector (16) button for the channel to Бе
recorded to put that track in the RECORD READY mode. When the button is
depressed, the RECORD TRACK LED will blink.
Depress the RESET button (18) of the counter display (15) to set the
record starting point to ZERO display.
3) The PITCH control switch (10) is set to NORMAL.
4) Simultaneously depress the PLAY (24) and RECORD (22) buttons апа the
channel whose RECORD TRACK selector button is depressed will enter
record mode and the RECORD TRACK LED will be 11%.
The output for the channel in the record mode will change to input
signal but the other channels will remain at reproduce output.
5.4 Overdub
1) Set the MONITOR selector (17) to SYNC and depress the RECORD TRACK
selector (16) button for the channel to be recorded to put that track in
the RECORD READY state. The RECORD TRACK LED for the channel whose (16)
button is depressed, wiil blink.
2) In this state, if the RECORD button (28) only is depressed, the green
RECORD LED (29) will blink, and the output of the channel whose RECORD
TRACK LED is blinking will change to input signal.
The meter (18) indication will also be for input levels.
3) If the RECORD button is depressed again, the green RECORD LED will go
off and all channels wil be in the SYNC state.
4) Simultaneously depressing the RECORD (28) button and the PLAY (26)
button puts the deck in the record mode. The output of the channel in
the record mode will be for input signal and the meters will also іпаі-
cate the input signal level. The output for other channels will be SYNC
playback signal and the meter will indicate the SYNC playback level.
5.5 Punch In/Out
1) The channel for punch-in is put to record READY by depressing the RECORD
TRACK selector (16) button. The RECORD TRACK LED for that track will
blink.
2) Set the MONITOR selector (14) to SYNC,
3) Depress the PLAY button (26).
Playback signals for all channels, including that for punch-in, can Бе
monitored.
4) While in this state, depress the RECORD button (29) only.
The green RECORD LED (29) will blink and the input signal for the
channel to be punched-in only can be monitored.
Depressing the RECORD button once again cancels input monitor for the
channel to be punched-in and all channels will change to SYNC playback
signal monitor.
Consequently, the output of the channel put in the record READY state
for punch-in by depressing the RECORD TRACK selector, and the VU meter
indications, are alternately switched between input signal and playback
signal each time the RECORD button only is depressed which allows free
access to tape cue and rehearsal monitoring for the musicians during
punch-in. |