VF-16 QUICK START – BUS METHOD RECORDING
(USING THE XLR INPUTS)
This method is used to route the XLR INPUT(s) to different tracks.**
PRIOR TO RECORD:
Since Program 1 (PGM-1) is a record-protected demo, you must first exit PGM-1 prior to recording and
disable record protect.
1. Press the PGM SEL button
2. Using the JOG wheel, turn until display reads “NEW PGM?”
3. Press the ENTER button *Note: From here you can name your program and press
ENTER ….or…. to skip simply press EXIT.
4. Using the JOG wheel, turn until display reads “REC PROTECT”. Press ENTER. Turn JOG
for display to read “OFF”. Press ENTER. Press EXIT.
The XLR inputs are located at the top of the VF16:
XLR Input G XLR Input H
The audio levels for these XLR inputs are controlled using FADER#15 & FADER#16 (bottom row)
TO START RECORDING (Bus Method)
For the following example let’s record on Track 1 using XLR Input H.
1. Connect your audio signal to Input H
2. Press the INPUT SEL button (located underneath the display)
3. Select the CH SEL#H button above fader H (16).
Display now reads “H” with “IN” underneath it.
To Next Page
Need help?
Inputs and Outputs
