1. Turn o unit prior to tting or
replacing batteries
3. Pull the tab upwards from the
top of the battery cover.
5. For best weatherproong, ensure
battery cover has a good seal by rmly
pushing lip into the bottom edge of the case
and pivoting it into position.
2. Using a cross head
screwdriver unscrew
the two battery cover
screws.
4. Take care removing the batteries.
Insert new batteries and ensure
correct polarity.
6. Re-t cover and screws.
• Weatherproof Sealed Case
• Dual Step Sensitivity
•Digital Circuitry
• D-Tec™ Sensing System (DTSS)
• Low Battery Drain
• CNC Machined Rollerwheel - Tru-Run™
•Multicolour (x6) LED
www.foxint.com
Indexed
Ergonomic
Tone Control
High Visibility
4mm LED
On / O
Toggle
Switch
Rod Friendly
Rubber Inlays
Battery
Cover
Power Out
Socket (2.5mm)
Indexed
Ergonomic
Volume
Control
High Quality
Piezo Speaker
Rigid 3/8”
SS Thread
ENGLISH
MICRON USER GUIDE
FEATURES
x6 Colour
Cycle Button
FITTING THE BATTERIES
DO NOT over tighten the battery compartment screws,
excessive force will damage the screw threads.
To Next Page
Need help?
General
