12. Take all the parts of the base from the package.
13. Assemble two feet with the crossbar by using the screws and nuts provided (Fig. 2).
14. Assemble the other two feet with the second crossbar (Fig. 3).
15. Then place this two units and assemble the last two crossbars in order to form a square.
16. Firmly tighten all the nuts and screws (Fig. 4).
17. Your base must look like the one of Fig. 5.
18. Before keeping on assembling the machine, turn the table saw upside-down and
remove the protective plate (Fig. 6).
19. Then use the angle adjustment lever to tilt the saw and remove the polystyrene that
blocks the engine (Fig. 7).
ASSEMBLY OF THE BASE
To Next Page
Loading...
