46
Cross cutting means cutting perpendicularly to
wood fibres’ direction (Fig. 23). To cross cut, use
the goniometer at 0°. Before using it, be sure that
it is locked on the desired angle.
This guide can be used on one of workbench’s
grooves.
For angle cut, adjust the cutting angle of the
goniometer by loosening and tightening its
screw, and press the workpiece against it (Fig.
24). Use the goniometer on the side on which it
does not risk to interfere with the protective cap.
Angle cut is a crosscut with the angled blade. Adjust
the saw blade on the desired angle. Use the
goniometer in one of the grooves in order that it
does not interfere with the protective cap.
CROSSCUT
ANGLE CROSSCUT
To Next Page
Loading...
