48
To trim pieces which are less than 150 mm wide, use
the rip fence only on the right side of the blade and use
the pusher to push the piece until it is completely cut
(Fig. 28).
Connect the dust-collection device to the back output of the machine.
A suitable extraction device or an external dust collector can be connected to the machine, in
the back side of the base there is the coupling for the aspiration pipe.
Always connect the table saw to an external dust-collection device, since the dust of different
kinds of wood can be dangerous for the health of the operator.
The aspiration capacity tested according the standard EN61029-2-1;2002 is 45%
We recommend you to always use a dust collector to remove the dust which has been
produced while using the machine. Besides, it is preferable that you clean accurately the
machine to remove all dust piles.
CAUTION: Before any adjustment, repair or maintenance work, and before changing the
blade, switch off the machine and disconnect it form any current source by removing the plug
from the socket.
In case you find out any damage to the protection devices or irregularities while processing or
checking the machine, you must get it repaired immediately by qualified persons.
Before use check that the protection and safety devices are perfectly efficient. After carrying
out the work, make a general cleaning of the machine by removing dust and chips.
In case of intensive use of the machine, the frequency of the can be the following one:
1- Daily
Suck up the saw dust that can pile up inside the machine and clean the ventilation inlets of the
engine.
Be sure that the protective cap can slide freely.
2. Weekly
Keep sliding the upwards, downwards and angle movement of the blade.
3. Monthly
ANGLE CROPPING
DUST EXHAUSTION
MAINTENANCE
To Next Page
Loading...
