SPECIFIC SAFETY INSTRUCTIONS FOR SPINDLE SHAPERS
1. Before connecting the machine to the power supply, ensure that all safety items are in their active positions and
check that they function correctly. If it is necessary to remove the doors or protective covers, turn off the switch
and disconnect the plug from the socket.
2. Kick-back catchers must be able to move freely and their functioning must be checked regularly.
3. Do not connect the machine to the power supply while the door or protective cover are removed.
4. Acquaint yourself fully with the locations of all switches before turning the machine on.
5. Memorise the location of the emergency stop switch so you can use it promptly at any time.
6. Take care to not touch any switches accidentally while the machine is being operated.
7. Do not touch any rotating tool by hand or any other object, under any circumstances.
8. Before performing any maintenance work inside the machine, switch it off and disconnect it from the mains
supply.
9. Do not alter the machine from its factory specification in any manner which may risk its safe operation.
10. If you are in any doubt about a procedure with the machine, contact a qualified person.
11. Ensure you regularly inspect the machine in accordance with the instructions.
12. After your work with the machine is finished, adjust and clean the machine so it is ready to be used again.
13. If the power supply fails for any reason, switch off the machine immediately.
14. Do not paint, allow to become dirty, damage, alter or remove the safety plates. If they become illegible or are
lost, contact the manufacturer for replacement plates.
15. This machine must not be used for curved work.
To Next Page
Loading...
