TRANSPORT AND STORAGE
While transporting or handling the machine, take utmost care.
When loading or unloading the machine, ensure that no-one is crushed by the machine! Do not walk under the machine
while it is being lifted by a crane or high-lift trolley.
During transportation, precautions must be taken to protect the machine against excessive vibration and humidity. It
should be stored in a shelter a temperatures ranging from -25°C to 55°C. The machine is packaged in a plastic tray
as standard and is transported this way.
Lifting the machine
The machine or its individual parts may only be lifted by means of an approved lifting devide with verified lifting capacity.
1. Prepare a high-lift truck (D) or a manual lifting carriage (F) with sufficient
lifting capacity.
2. Put the forks (G) below the machine as shown in Fig. 1.
If you are using a crane (E) or similar hoisting equipment, proceed as
follows :
1. Prepare four lifting belts (H) or steel ropes at least 2m long with
sufficient lifting capacity.
2. Fix the ropes to the hook of the crane with the required capacity.
3. Place the other end of the ropes on lifting rods under the machine (lifting
rods not included)
4. After lifting the machine slightly, check the stability of the machine as it hangs from the ropes.
5. Lift the machine carefully and slowly, moving it without any rapid changes of pace.
To Next Page
Loading...
