Fox LiveValve 32 Step Cast - Page 21

21
REAR SHOCK REBOUND SETTING
The rebound adjuster controls the rate of speed at which the shock extends
after compressing. The rebound setting is dependent on the air pressure
setting. For example, higher air pressures require slower rebound settings.
You will use your air pressure to find your rebound setting.
Turn your rebound adjuster to the closed position (full clockwise) until it
stops. Then back it out (counter-clockwise) to the number of clicks shown in
the table below.
Air Pressure (psi)
Recommended Rebound
Setting
<100 Open (counter-clockwise)
100-120 16
120-140 14
140-160 12
160-180 10
180-200 8
200-220 6
220-240 4
240-260 3
260-280 2
280-300 Closed (clockwise)
Do not exceed 350 psi, the maximum
Live rear shock air pressure!
REBOUND
ADJUSTER
LEAST AMOUNT OF
REBOUND DAMPING;
SHOCK REBOUNDS
FASTEST
MOST AMOUNT OF
REBOUND DAMPING;
SHOCK REBOUNDS
SLOWEST
CLOSED
(CLOCKWISE)
OPEN
(COUNTER-CLOCKWISE)
17 15 13 11 9 7 5 3 1