GB
STALKER 2 MAN DOME X
GB
STALKER 2 MAN DOME X
Instructions
Assembly
(A)
(D)
(D)
(B)
(C)
Unfold all poles and join together, lay out dome flat on ground as shown, push poles A & B (two
longest-coded red) through flaps from corner to corner. Then push pole D (coded blue) through from
front to back (fig.1) and connect making sure pole D is underneath poles A & B. Thread pole C
(coded green) through flap at front as shown.
Fit pole ends over metal pins to front position 1 (fig.1), lift and bend poles, fit pole ends over metal
pins to rear position 2 (fig.1). Bend pole D and fit pole end over metal pin to rear position and con-
nect opposite end in pocket. Finally connect pole ends to pole C over second metal pin to position 1
(fig.1).
(A)
(B)
(C)
(A)
(B)
(C)
(D)
1
Fig.1
2
1
To Next Page
Loading...
