Make Your First Engraving
-14-
2. Power on the machine. Connect the control board to the PC via USB, select the COM port recognized by the PC. Click the
“connect” icon. You can see two red lights lighting up on the control board.
1. LaserGRBL support custom buttons. Usually custom buttons are pre-added by default, if not, you can add them manually.
A nice set of pre-defined custom buttons can be downloaded here: http://lasergrbl.com/usage/custom-buttons/
- Right-click in button area to import custom buttons.
- After importing, you can see the following icons:
To Next Page
Loading...